It should be understood when installing CNC steel bending hoops: When installing the numerically-controlled steel bending hooping machine, it should first be kept on a relatively flat foundation. It is best to put some cushions to prevent the machine from vibrating at high speed and on the ground. . The connection between the host and the slide is preferably on the same straight line. Check whether the punch is engaged with the cut. If it is not engaged, adjust the height of the lower pulley, adjust the slider inside the slide to the required size, and then use the screw. Fixed, in the use of CNC bending machine should pay attention to the maintenance of pressure, generally 4MPa is appropriate, too high may cause deformation of the steel or equipment damage.
When using a
CNC Rebar Bending Machine in case of failure, you should understand the treatment method:
Broken wire. First of all, check the angle of the straightening block to see if it is too large, or if the knife is not returned, the pressure spring on the wire feed roller is too loose and the material is not good.
When bending a double tendon, there is a tendency for a steel bar outside to bend off the axis, and the response to this is to reduce the speed of bending.
Turning the cutter head, this is a relatively simple fault, as long as the dynamic knife sensor switch can be adjusted.
The phenomenon of running silk appears. Check if the pressure spring is over-tight, the tension spring is too loose, or the wire rod under the slide is not in place, and the slide does not slide.
Bend wire phenomenon. You can adjust the angle of the straight block to see if it is aligned with the straightener. The roll groove is in a straight line.
After the delivery of the steel bar is not straight, often upturned under the bend problem, then you should adjust the bottom and bottom of the top of the group of rounds, the top of the opposite direction in the past.
Inquiry Basket ( 0 )
